How do I get my Wii Remote to work?
Why is my Wii Remote not connecting?
Resync the Wii Remote by removing the battery cover and pressing the red 'SYNC' button. Then press the SYNC button on the Wii console. If the steps above do not work, remove the batteries of the Wii Remote and leave them out for at least 2 or 3 minutes. Reinsert the batteries and sync the Wii Remote again. via
How do I fix an unresponsive Wii Remote?
Press and release the red button located under the battery compartment. The blue lights on the front of the remote will blink. Press and release the "SYNC" button on the front of your Wii gaming system. The "Player" light on the gaming system stops blinking and stays on, the resetting process is complete. via
Why is my Wii Remote flashing blue and not working?
The blue lights on the front of the Wii remote should blink. Quickly, go back to the front of the Wii console, open the SD card slot and press the red "Sync" button. Look at your Wii remote. It is successfully re-synced with the console when the lights quit blinking, and one blue light remains on. via
How do you sync a Wii Remote to a Wii U? (video)
How do you reset the Wii?
Locate the "reset" button on the front of the Wii console. Hold it down for a few seconds to reset the device. Wait for the home screen to appear, then hold down the "power" button on the front of the Wii until the power light turns red and the Wii shuts down. via
How do I reset my remote control?
How do you troubleshoot a Wii?
Power off the console and unplug the power cord for a few seconds. Plug the power cord back in and turn the Wii back on. At the "Health and Safety" screen, open the small door on the faceplate of the console. Hold the red sync button for at least 15 seconds. via
How do I get my Wii Remote to stop flashing?
Press and release the SYNC button just below the batteries on the Wii Remote; the Player LED on the front of the Wii Remote will blink. While the lights are still blinking, quickly press and release the red SYNC button on the Wii console. When the Player LED blinking stops and stays lit, the syncing is complete. via
How do you sync a Wii Remote to the Wii U without the sensor bar?
when the "point the wiimote at the TV" screen, plug in your Wii Classic Controller and move the left joystick; a hand cursor should appear. Highlight "gamepad and TV" or "TV only" as you please, then press A on the classic controller. It should boot right to Wii mode without the sensor bar now. via
Why won't my Wii Remote sync to my Wii U?
Possible solutions. Ensure that the Sensor Bar is plugged into the Wii U console and connected properly. If it is plugged in, unplug it and plug it back in a few times, checking after each attempt to see if the cursor shows up. You should feel it click into place when it is fully inserted. via
How do you reboot a Wii?
If the screen doesn't change for a few minutes, try pressing the power button on the front of the Wii console. Pressing the console's power button should quickly reboot it, but if the console doesn't power down, press and hold one of the power buttons until it does. via